Main Forum > General Computer Support
SFC doesn't start, even with Admin CMD SFC /scannow
friedmonky:
Bubba, download the System Update Readiness Tool for your OS from the link below. Run it and then reboot when it is finished. Then try installing SP1 again.
http://windows.microsoft.com/en-US/windows7/What-is-the-System-Update-Readiness-Tool
Shane:
The repair install is actually doing an upgrade. So you should be able to use the SP1 disk you got.
At the same time you can also try installing SP1 first after the readiness update is done and see how it goes :wink:
Shane
friedmonky:
--- Quote from: Shane on February 04, 2012, 10:15:06 am ---The repair install is actually doing an upgrade. So you should be able to use the SP1 disk you got.
--- End quote ---
Sorry about that. This is absolutely correct.
Bubba Euler:
Guys, actually, I've accomplished all of the above, with no SP1 install. I found http://msft-dnl.digitalrivercontent.net/mvista/pub/x-15-65733.iso. I downloaded and burned a DVD-R (3.224,686,592 GB). It's a Win7 Home Premium 64-bit (x64) ISO file via MS, itself. This should do it 'cause there's no SP1.
Am I on the right track?
Me thinks we're doing good!
Shane:
That one I sent you to with SP1 would work as well. Might as well use the SP1 version so you dont have to install SP1 afterwards :wink:
Shane
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version