Main Forum > General Computer Support

XP BITS not starting up with error code %%1290

<< < (2/2)

GlenT:
Hard to say. I followed the procedure noted in my last post and got BITS functional, but not loading (prior to that, it would not even attempt to load). I didn't run the full set of fixes prior to, but only ran the fixes that I thought would have a bearing on the problem, and that failed. I can't say for sure that your software was the entire fix, or whether it was a combination of my fiddling and your software.

Have you had any other experience with %%1920 errors?

Shane:
The things about some of the repairs is that a lot of them should be ran together, such as permissions, WMI and such because a lot of of them use each other in Windows. Like the Windows firewall uses WMI. While I do have a lot of things covered in each repair normally the best thing is to run all the repairs, thats why I have them in the order I do. The permissions are first, because if we dont have permission to replace regkeys the repairs would fail.

But as long as your working right now thats all that counts :-)

Shane

GlenT:
OK, that makes sense. I don't think that I ran the first two fixes on the first try, because I wasn' t anticipating any permission changes, due to it being a fresh install from the OEM recovery CD. I did run those fixes on the second try, so that may have made the difference.

Navigation

[0] Message Index

[*] Previous page