Main Forum > General Computer Support

WMI Repair Tool

<< < (7/9) > >>

Shane:
OK good we can mark memory off the list :-)

Ok so WMI is failing and you had other problems. When you try to do a repair install Windows setup fails.

I had you check the memory and it was good, did I have you do a bad sector check on the drive yet?

Where you open a cmd.exe as adminstrator and then put in
chkdsk C: /f /r

hit enter and it will say the drive is in use would you like to schedule it, hit Y

then when you reboot it should do a very long chkdsk on the system since it will test every sector on the drive.

Shane

RocketNut:
I tried your check disk but an error, Please see the attached screen shot. I don't know how make me the adm.

parkd1:
Do a right click on Command Prompt then you will see a menu pop up and you will see run as administrator.

Shane:
Correct, right before you open cmd.exe in the start menu right click on it and choose run as administrator :-)

Shane

RocketNut:
OK I got it to run. I do not think if there was any errors, I did not see the last test because it restarted before I could read it. It did cuase some thing because I got the blue screen of death, with a message of "contact your tec support or adm for fewer assistance" It does not reboot and I cycle the power to reboot. What does this message mean  :sad: Before when the blue screen came up it would do a dump to log file (I think) then reboot.

Navigation

[0] Message Index

[#] Next page

[*] Previous page