Main Forum > General Computer Support

DLL Issues - Can't Install a lot of programs, some programs won't start.

<< < (4/4)

Boggin:

--- Quote from: jraju on August 14, 2014, 11:47:34 pm ---Hi,

            When you run the Chkdsk utility program in read-only mode on a volume that uses the NTFS file system, Chkdsk may not detect corruption in the disk structure. This behavior can occur if the $logfile data region in the Master File Table is damaged.
                 So the use of chkdsk /f would fix this.

--- End quote ---

I was responding to your belief that the /r switch did not correct system file errors - but this discussion is detracting from help for the OP, whenever they decide to return.

jraju:
Hi, Boggins
                      This is from my personal experience that there is difference when i used check /r. When i used the /f/r then , my system resumed normal and it fixes so much index errors and other errors. So, I advised. I am really happy to note your suggestions

Navigation

[0] Message Index

[*] Previous page