Main Forum > Tweaking.com Support & Help

Windows Repair (All in One) v2.8.6 Released

(1/4) > >>

TweakAS:
Hi, just joined and noted after update to version 2.8.6, the process stops at "19 - Repair Volume Shadow Copy Service" on both windows 7 home and prof machines. Previous version OK and Version 2.8.5 was actually fine and tweaked the machines well. Just giving feedback in case there is a solution. Just tested again and results attached in capture image.

Shane:
Is the cmd.exe window open? That is where the commands for the repair is ran. The log shows that it ran under the current user account and then it was running the repair again under the system account.

To run the command under the system account the program uses the file "tweaking_ras.exe" and that launches the cmd.exe under the system account.

If for some reason the file was removed or not working during the repair then the cmd.exe window would have never opened and so the program would sit there waiting for it.

Shane

TweakAS:
The cmd.exe pop-up window starts ok but cannot see it when it reaches step 19 (as shown in the image earlier) in version 2.8.6 and win 7 home (VM). This is where it takes ages to proceed until I gave up and closed the programme. I can see others having the same issue as I also use win 7 prof (32-bit) with same issue. This was fine in prior versions and the last version 2.8.5. These showed the cmd.exe pop up box to do its task and finish OK. Hopefully there will be a solution to improve this soon so it works as it did before.

Shane:
v2.8.7 is out, see how that one does for you :-)

Shane

TweakAS:
Downloaded v2.8.7 today with the same following results as before - see attached images. :sad:

Navigation

[0] Message Index

[#] Next page