Main Forum > Tweaking.com Support & Help

All In One Repair Stalls at 02.03 File Permission G:1

<< < (2/2)

RAK43:
Shane
Ran the program again last night including all of the preliminary scans. Then ran the all in one program but de-selected 02.03 File Permission G:1. The program ran without incident and restarted at the conclusion. I then ran the all in one program with only 02.03 selected and it ran for 4 hours before I stopped the repair manually.  Something appears to be corrupted in the File Permission G:1 file. Any suggestions? System seems to be running OK. Is this a problem or an irritant? Originally ran the program due to periodic system lock up. screen looks normal, hourglass running continuously, and no ability to activate any of the icons. Required manual shut down and reboot.
Thanks,
Rick                   

Shane:
When the program sets the permissions it uses the setacl program in the files folder. Either the 32 or 64 bit depending on the system. That exe is what sets the permissions, when you get to that repair is that exe running?

It might be having trouble with a certain file or folder. Do you have it run only on the C: drive or do you have other drives you have it run on? (I see G: in your last post)

Shane

RAK43:
Shane,
The G drive is my mirror image Carbonite backup drive. It would seem that when running the All in one program it is not necessary to include the G drive. Is the answer simply to deselect this drive when running the program?
Thanks,
Rick

Shane:
Correct. Just have it do the Windows drive and skip the G: drive. Looks like it has it protected so the setacl is trying to set the permissions but carbonite might be fighting it, so it never ends. :wink:

Shane

Navigation

[0] Message Index

[*] Previous page