Main Forum > General Computer Support
(solved)would 2 gb ram for my intel mothre board spoil the boot
Willy2:
See reply #5.
Boggin:
--- Quote from: Willy2 on May 01, 2015, 06:54:07 am ---See reply #5.
--- End quote ---
Thanks Willy.
Boggin:
According to the Crucial scan, you would want the 1GB DDR PC2700 which is 2.5V
It's unclear what you have been trying as putting a RAM module into another computer to check it isn't going to work unless the motherboards are identical or the other mobo uses the same spec.
Can you give us a recap of what you have tried and have you checked what the new stick is ?
I think I would have tried to get the memory sorted before reinstalling as hardware trumps software.
jraju:
Hi, Boggin The problem i thought was that my old ram finishes and the technician given one not compatible as the monitor stops and flicking on and ff , at the stage i posted. Yesterday, i have taken the pc to my technician and there i could see that it goes past everything and installation could be done. But i told my experience. He said the two rams are working perfectly , and suggested to use one ram at a time for maximum performance and his ram is also compatible to my mother board. But sometimes, one ram diminishes the retention memory of other ram. This could be seen from processor tries to run and you get overheat messages. In that case, he asked me to take away one ram and run with one ram. I came to know that ram sticks are no issue.
I think probably the monitor resolution is the problem. He says that he will correct it. Probably true. He has loaded a trial version of win 7 ser pack 1 by using his lcd monitor. Mine is crt lg 700 monitor. So, probably the drivers for his monitor resolution would have been fixed when he installed his version. So, when i tried to boot, i was getting this problem of resolution and computer monitor auto closes and flicking. strange. I tried to default bios settings and also took out the cmos battery and short circuited to completely restore the factory bios settings. But thlyis has not touched the screen resolution settings , i think, and so it does not work. I was often greeted with alert that windows did not start successfully. a recent hardware or software would have caused error ultimately let to start up repairs and finally that those could not be done and no boot.
Is there a way how could this be solved. Normally tech guys are only asking as the system and not monitor when asking for repair. why this has happened even when i restored the bios to older date. Load drivers could not be used to install graphic drivers as they are exes. He says me to buy a lcd monitor which support high resolution if he could not fix the resolution problem. Pl give me suggestion now.
jraju:
http://www.sevenforums.com/tutorials/15856-device-manager-access-during-windows-7-installation.html
Please see this link. Is it possible to run install as suggested. Because, once you load the windows, then only you could safe mode everything. How it is possible to allow boot from dvd menu and then press f8 to boot in safe mode.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version