Main Forum > General Computer Support

Multiple Errors Runnning Tweaking Scans -- Not able to get into Safe Mode

(1/2) > >>

richfed:
Hi -

I am running a clean [from HP Recovery Disks] Windows 8.1 Pro w/Media Center 64 bit on a HP Envy Phoenix desktop. Fully updated via Windows Update. Tweaking version 3.14 Pro

Was testing the program, and turned on the F8 option, but Windows will not boot into Safe Mode. Upon initiating the restart, I immediately start tapping the F8 key, but the PC boots into normal Windows.

The Pre-Scan shows reparse errors [not sure what that means]. Check Disk says I need to fix errors on the hard drive. Dism says it is corrupted, but running the cleanup-image /RestoreHealth command tells me in cannot connect. I did the Shutdown Step & Malwarebytes Step, but without being able to get into Safe Mode, I'm not sure these results are valid.

Frustrating ... I just went through a recovery and my system still does not seem normal. Just replaced the OS hard drive, as well. Brand new.

Shane:
Have the program try to enable the F8 menu again, a black window should open up with the results, grab a screen shot of that and post it for me. :wink:

Shane

richfed:
It always says it is successful.

Boggin:
Try using msconfig to boot into Safe Mode and perhaps WR will fix what is wrong.

Shane:
The command worked, if you are on a laptop it is possible the F8 key is set to where you have to us the FN key with it, some laptops that is off and you dont have to use FN on others it is on, bugs the crap out of me lol

Shane

Navigation

[0] Message Index

[#] Next page