Main Forum > General Computer Support

PC wont open now with Windows 10

<< < (3/3)

Phototaker:
I think that part of the problems that I experienced came from the fact that I think Windows 10 go itself into a knot when it came to identifying which USB was plugged in.  I have tried plugging in a few passport drives that both myself & a friend had & observed the following.  I could plug in a drive & it would say that it was 'g' drive.  I could then go & try another drive of both the same & different capacity & it too was called 'g' drive.

I have held off doing what I had done before I tried updating to Windows 10.  I wanted to get some logic with both the drive letters & names.  I have both  a CD R/W drive a s well as a separate Blue-ray R/W drive. Because these 2 don't get plugged in I wanted them well away from other drive letters so I called the 'Y' & 'Z' drive.  The a plug in SD card reader was called 's' drive.  A 500gb red passport that was called 'R' drive etc.

Is there any safe way to do this?

Maybe some of these names was picked up by Windows & created a conflict with other drives it wanted to assign the same letter to.  Is this possible & if so how does one fix this?  I have yet to read of any solution as to why there are many other people saying that their WD 2TB Passport Elite drives won't open in Windows as they can get a message, that might take 5 minute for Windows 10 to cough up,that some parameter is wrong?

Navigation

[0] Message Index

[*] Previous page