Main Forum > Tweaking.com Support & Help
Error hooking API upon Installation
Boggin:
That would confirm it was related to an antivirus program as Shane has found -
https://forum.kaspersky.com/index.php?showtopic=362231
AV programs aren't loaded in Safe Mode.
You only need to post the CBS log if sfc /scannow reported it was unable to repair all files.
It sounds like your hard drive is a bit full.
You haven't said which version of Windows you are using.
If Win 7 then go Start - type disk cleanup - right click on Disk Cleanup and select Run as administrator.
If later than Win 7 - go Start - type disk cleanup and press enter.
When it has done its scan, click on Clean System files where it should find a lot more to remove.
You can gain some more space on your hard drive by turning Hibernate off.
For Win 7 go Start - type cmd - right click on cmd and select Run as administrator and accept the UAC.
For later, Open a Command Prompt (Admin) - accept the UAC then enter powercfg -h off - that frees up about 6GB for me.
Check to see if you have 15% of the total hard drive free and then you can run a defrag from the admin command prompt by entering defrag /c
This will analyze and defrag all volumes as necessary.
If you still don't have a min of 15% free then you are going to have to copy large files such as photos etc onto an external HDD of sufficient capacity - but I'd do that anyway as Virtual Memory relies on free space on the hard drive.
Anatoli Lioultchenko:
PC Win7x64 Famille Premium.Free disc C: space is 180GB.
Boggin:
Free out of a total of what ?
Anatoli Lioultchenko:
Acer(C:) Capacity 223,95GB Free space 180,15.
Boggin:
Well that should be enough but when you get that message it can be indicative of a failing HDD.
Can you download the 30 day trial version of HDSentinel to see what that reports for your drive.
Hit the green button then uninstall when done so as to stop the clock to use it again as and when.
http://www.hdsentinel.com/
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version