Main Forum > Tweaking.com Support & Help

Deceptive progress counter in disk clean-up, (Scan & Repair drive)

(1/2) > >>

Catullus:
I am a new user of Tweaking, following the instructions module by module I selected the 'Scan & Repair drive' module. The module appeared to run correctly, but the progress counter did not increment correctly; it froze at '10% complete', leaving me completely in the dark as to the progress of the operation. Since I have two very large capacity hard disk drives, that made me very uncomfortable. I could not tell if the software operation was proceeding correctly, if it had gone recursive, or if it had stopped completely.
Please, may I request that this note be treated as a 'bug report' and a fix designed and implemented.
P.S. I like the software and it did a good job with no hang-ups, thank you.
Sorry, I left out some critical information, in my original post.
My operating system is WIN10 Home, fully updated and patched. Similarly my Tweaking software is fully updated and patched. Too many demands on my time lead to a rather hasty, and incomplete post.

Boggin:
I've moved this thread to the Tweaking.com Program and Site Help section, but did you run the program in Safe Mode with Networking ?

Catullus:
Definitely ran the program in SAFE mode, followed instructions rigorously, starting with a clean boot as instructed, then into Admin account and safe mode; cannot remember if I used Safe Mode with Networking.

Boggin:
If you used the program's option to boot into SM then it will have booted into Networking as it needs to be connected to the Internet for the Apps Store repairs for Win 8/8.1 and 10.

However, in Win 10 in SM with N, that auto disables wireless and you should have seen a red cross on the wifi icon in the system tray and while you can manually reconnect wireless through the icon by entering the wireless password, it's just as easy to wire up.

Can you check that by running the program again in SM w N to see if it performs the same, then I'll pass it on for you if it does.

Catullus:
Thank you for the quick responses, they are much appreciated.
I will do as you ask and run the program again, but, due to the size of my hard disks, the disk clean process takes several hours; consequently the rational way to do a disk clean is overnight. Ergo, I will not be able to reply until tomorrow March 16 2017.

Navigation

[0] Message Index

[#] Next page