Main Forum > General Computer Support

Print Spooler Error

<< < (2/2)

KR:
Boggin,
when starting in a clean boot ... can I still use the printer? Only when using the printer the error event appears.

Boggin:
I must admit that is something I've never done, but give it a try.

jraju:
Hi, The solution, i gave to you was from microsoft error data base, which you could have tried. But since the printer is working, i do not think , that you are facing any problem. I went to eventid.net, which gives you ideas about the error. I think it is to be subscribed to see so much solutions for the error event. I did not subscribe , but anyhow, went to the microsoft site, to give a resolution. If it is not working, did you check the spooler folder to find something old files that are not in use by the system. Normally , when the device driver is not update, the device will work, but will post anylog to the error event, by suppressing the error. Just may be a log in that folder.
                     Go to eventid.net and post your error and you could go deep in to it

Navigation

[0] Message Index

[*] Previous page