Main Forum > Tweaking.com Support & Help
Safe mode to run the Windows repair tool
Boggin:
I'll ask Shane if the dual boot could cause a problem, but I'm sure other members who dual boot have also used the program okay.
In normal mode can you try the bcdedit cmd again and then go Start - type eventvwr and press enter when it comes up.
When Event Viewer has read the data, click on Error then on View All Instances of This Event in the lower right pane.
Look for date and timed stamped errors that coincide with your attempt at that cmd - clicking on any will give more info in the pane below.
If there are any can you let me know what they are.
rayburke30:
:artist:
Tom 3/11/2019,
Below what you sent with response in Red
I'll ask Shane if the dual boot could cause a problem,
but I'm sure other members who dual boot have also
used the program okay.
In normal mode can you try the bcdedit CMD again and then go Start - type eventvwr and press enter when it comes up.
(done this in normal mode about 7.50am 3/11/2019)
When Event Viewer has read the data, click on Error then on View All Instances of This Event in the lower right pane.
(I can't find read the data tab see attached "event viewer (local)3-11-2019)
Look for date and timed stamped errors that coincide with your attempt
at that CMD
- clicking on any will give more info in the pane below.
If there are any can you let me know what they are
Boggin:
The wording is a bit different in yours but click on View events in this log in the lower right pane and then you will be able to view the date and time stamped errors.
rayburke30:
:wink:
Tom 4/11/2019,
OK will attempt to do so and let you know of results?
Ray
PS your replied-
« on: Today at 01:58:35 AM »
The wording is a bit different in yours but click on View events in this log in the lower right pane and then you will be able to view the date and time stamped errors. (I think I did it the right way see attached "Event Viewer 4-11-2019")
Boggin:
Given what that reports, for me, suggests you will need to perform a repair install and ensure you get KB4490628 and KB4474419 so that updates will continue after July 2019.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version