Tweaking.com Support Forums

Main Forum => General Computer Support => Topic started by: jeffreyabr on July 24, 2012, 09:56:43 pm

Title: SFC Scan Results
Post by: jeffreyabr on July 24, 2012, 09:56:43 pm

Trying to understand the results of my SFC Scan. Can anyone help me? CMD said it got to 42% verification before it ended.

Title: Re: SFC Scan Results
Post by: Shane on July 25, 2012, 03:28:36 pm

From what I can tell it says that some files are corrupted and then it just stops. Almost like the SFC crashed.

It would be a good idea to run a chkdsk on the system next :wink:

Shane

Title: Re: SFC Scan Results
Post by: jeffreyabr on July 25, 2012, 07:07:34 pm

Quote from: Shane on July 25, 2012, 03:28:36 pm

From what I can tell it says that some files are corrupted and then it just stops. Almost like the SFC crashed.

It would be a good idea to run a chkdsk on the system next :wink:

Shane

Hmm... I've been down this road before, and it doesn't end well. Last time I needed to do a chkdsk to correct an issue related to contracting the Win 7 Virus that was floating around. Long story short, my laptop will not do a chkdsk.

If I tell my computer to do a chkdsk, it says it cannot run because the drive is in use and cannot be locked while it is running. If I try to do a chkdsk after a restart, the computer reboots without running the chkdsk. There is a step after that, but I forget what happens (I think it involves starting msconfig and commanding Windows to start in Minimal mode, but that messed with my computer). Any suggestions?

Title: Re: SFC Scan Results
Post by: jeffreyabr on July 25, 2012, 10:41:37 pm

I managed to run a chkdsk when I put the Windows Install DVD into my laptop and entered chkdsk /f

Then I ran another sfc scan and attached are the results.

Title: Re: SFC Scan Results
Post by: Shane on July 26, 2012, 10:36:18 am

Looks like in went a lot further this time.

Did SFC finish this time?

Shane