Tweaking.com Support Forums
Main Forum => Feedback & Suggestions => Topic started by: Willy2 on November 18, 2021, 07:42:22 pm
-
I have a proposal to "Clean up" the program code in Windows Repair (WR). WR runs a number of MSDOS command in several repairs and those commands can "cleaned up". Inside WR one can find a sequence of commands something like this (in bold & italics):
REM register an number of files in the "System32" folder:
regsvr32.exe file.dll /s
regsvr32.exe file2.dll /s
regsvr32.exe file3.dll /s
REM test if a computer is a 32 bit or 64 bit system
IF NOT EXIST "C:\windows\syswow64\regsvr32.exe goto nextcode
REM register a files number of files in the "Syswow64" folder
REM target the "Syswow64" folder.
regsvr32.exe file.dll /s
regsvr32.exe file2.dll /s
regsvr32.exe file3.dll /s
.nextcode
This piece of code contains a "goto" command and that's NOT recommended.
The lines that target the "Syswow64" folder can be improved/cleaned up. Those lines in WR can replace that with slightly different code that also would target the "Syswow64" folder. Instead of using "goto" WR can use a slightly different "IF" code and NO "goto".
Then the lines that target the "syswow64" folder (see the example above) would become something like this (in bold italics):
REM test if a computer is a 32 bit or 64 bit system
IF EXIST "C:\windows\syswow64\regsvr32.exe (
REM register a files number of files in the "Syswow64" folder
regsvr32.exe file.dll /s
regsvr32.exe file2.dll /s
regsvr32.exe file3.dll /s
)
-
I've emailed Shane with a link to your thread for his consideration.