Tweaking.com Support Forums
Main Forum => Tweaking.com Support & Help => Topic started by: Scott on February 07, 2013, 03:21:29 pm
-
I have a Toshiba Satellite, it was vista and make into XP with Windows 7 Ultimate. (32 bit). When I load your program, I have no problems, I follow each step.
When I turn off the computer and later start it a block pops up saying power supply and it shuts down, I can bring it back up but it shuts right back down.
I have to run system restore in able to use the computer at which time I lose your program.
Any Idea's, can I uncheck something in the menu of the program that will by pass this problem.
I put this program in my other Lap Top and it works fine. I'm at a loss. Scott
-
Power supply? Anyway you can get a picture of when you get that error?
Also what we can do, if your willing, is to do 1 repair at a time, reboot and see when you get the error. That way we can see which repair is triggering it, and then I can tear into what the repair does and find an answer :-)
Shane
-
Can I try the one repair at a time by un checking the menu box that shows up, On the picture of post, it's too quick to for a screen shot, it'll shut down.
I have plenty of time, just need you to advise me what to do. Scott
-
When you get to the repair list just click the unselect all button. Then select the first repair and start there. After each repair do a reboot, and do 1 repair at a time :-)
Then remember what the last repair you run is before the reboot. This way I will know which repair is the trigger, then I can find an answer :-)
Shane
-
Very good Shane, I'll start in the morning and work it until I find where the problem is, I will then advise you of it and we can go from there.
Thank You.
Scott