Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - darkhorse

Pages: [1]
1
I started Windows Repair 4.5 hours ago and most of the early repairs made obvious progress showing lots of Drive usage and CPU usage, but on "Repair WMI" the command prompt says "Step 3 of 3 - Searching system for MOF and MFL files to add back to WMI..." and it has been stuck on that part for almost 2 hours. Occasionally CPU usage pops up from 25% to 25.83% or something but it is usually static at 25% for minutes at a time, similar story with Drive Write.

Is this normal behavior? How long should I let it run?

Pages: [1]