Main Forum > General Computer Support

Vista Startup problems

<< < (7/19) > >>

Xas1953NC:
This what Speccy comes up with on the Ram specification. I have 2 slots each with 2 gb of matched memory sticks. Vista shows total of 4 gb of memory on the spec page.

RAM
Memory slots
Total memory slots   4
Used memory slots   2
Free memory slots   2
Memory
Type   DDR2
Size   4096 MBytes
Channels #   Dual
DRAM Frequency   533.1 MHz
CAS# Latency (CL)   7 clocks
RAS# to CAS# Delay (tRCD)   7 clocks
RAS# Precharge (tRP)   7 clocks
Cycle Time (tRAS)   24 clocks
Bank Cycle Time (tRC)   32 clocks
Command Rate (CR)   2T
Physical Memory
Memory Usage   25 %
Total Physical   3.25 GB
Available Physical   2.41 GB
Total Virtual   6.73 GB
Available Virtual   4.98 GB
SPD
Number Of SPD Modules   2
Slot #1
Slot #2

Boggin:
Some methods to run the memory test and where the results would be http://www.bleepingcomputer.com/tutorials/using-vista-windows-memory-diagnostics-tool/

Shane:
Yes, you need to run an actual memory test.

Try as Boggin suggested and let me know :wink:

Shane

Xas1953NC:
Hello Shane, I do not have a Vista CD/DVD and I did use the method of clicking on the Start button, typing memory, clicking on the resulting memory icon and selecting the recommended check on a restart. During the checking prior to the computer completing booting up nothing showed on the monitor of any problems. I could not finding a resulting log file to tell me the result of the memory test.

Boggin:
It should have given the status in the memory check window as it was checking.

Go back to my post in how to create and post a Boot log and post that.

Navigation

[0] Message Index

[#] Next page

[*] Previous page