Main Forum > Tweaking.com Support & Help

Safe mode

(1/7) > >>

BarbaraWhynot:
Hi. I downloaded windows repair yesterday on my laptop and put my computer into safe mode. I can’t get out and I don’t know if the program is doing something behind the scenes or not. Yes I tried all the Microsoft key plus R  and I tried restarting etc. Nothing has worked. I just continually have the main screen and can’t do anything. Can someone please advise on whether this takes time   Thx

Boggin:
This was a problem with an earlier version of the repair program which was subsequently resolved.

However, open a Command Prompt (Admin) and enter these cmds and then reboot which should take you back to normal mode.

bcdedit

Look for Windows Boot Loader - this can either be {current} or {default} then enter this cmd using yours but I will example {default} in this cmd -

bcdedit /deletevalue {default} safeboot

Let me know if these cmds work for you.

I'll check out what the program does for me when I use it to boot into Safe Mode with Networking and get back to you.

Boggin:
It rebooted fine back to normal mode for me.

Did you run the repairs before rebooting to find you were stuck in Safe Mode ?

BarbaraWhynot:
I did not so the repairs and then do safe mode as it said to go into safe mode first. I can’t do anything. I can’t get any commands to work. I can’t get out of the main screen.

Boggin:
Can you check to see if you have a restore point back to before you installed the program ?

Navigation

[0] Message Index

[#] Next page