Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Clade

Pages: [1] 2

Thank you for your guidance.


Knowledge as it proceeds, only that.

Yes, there is the possibility of transferring files from one device to another. In this case, it is the transfer of a file from one folder to another folder on the same machine.
The equipment is not broken.
Transferring the file as proposed here, it becomes easier to resolve a crash issue, when it is known which file is corrupted or missing, since in the operating system, a copy of the file is corrupted.

The indicated material shows the question about equipment that is functional. I refer to those cases where the equipment is functional.

In case here, taking advantage of the example and as I am not an expert at command prompt, I would if possible, someone would demonstrate how this command would be to cause the file to be transferred from one folder to another folder, considering the equipment crash

Sorry for my english, my language is portuguese Brazil

In an attempt to copy the fvevol.sys file

C:\>copy C:\Windows\WinSxS\amd64_microsoft-windows-s..tartup-filterdriver_31bf3856ad364e35_10.0.17134.441_none_102acad936040081\fvevol.sys C:\Windows\System32\drivers
Substituir C:\Windows\System32\drivers\fvevol.sys? (Sim/Não/Todos): s
Acesso negado.
0 arquivo(s) copiado(s).

After requesting the replacement and confirmation, the message = access is denied and 0 file copied. Remembering that the command prompt is in administrator mode.

Possibly this is a matter of file ownership.

If someone knows how to solve it. . .

Thanks for your attention.

Yep! Before backing up, I also try to leave the system intact, use SFC, including all updates, including software.

As various software tests, in the install / uninstall, rarely, but occurs, difficulties with file corruption. But I like that kind of challenge.  I like to get "detonated" equipment to leave them in optimum conditions of use, which depends on software.

I configured the Registry backup to make a daily backup.

No. It is that today I made a correction of corrupt files. Normally I make system image. It would be much quieter if it worked, as I wrote.

Sorry for my English, it's not official language.

The question is whether Registry Backup includes all the files. . . which are scanned by the SFC / scannow command.

This doubt concerns the possibility of after SFC / scannow without corrupt files by creating backup with Registry Backup, at some point where the same command show corrupted files, could you use Registry Backup for fix?

Thank you for your attention!


Everything Else / Re: Gpedit - what's the real need?
« on: February 16, 2016, 06:23:22 AM »
More out of curiosity Julian! Know the real importance, as there are tutorial to install it.

Everything Else / Gpedit - what's the real need?
« on: January 27, 2016, 01:26:31 AM »
Hello everyone!
Sorry but English is not my official language
In your opinion what is the real importance of GPEDIT because in some OS (home, starter ...) is not available.
I read articles that teach install gpedit where it is not installed.
Install or not?
Thanks for your attention!



Correct, the backup line is important that they be as close to the current date. I remember a backup on an external disk with more than one year old, difficulties with browsers, antivirus. . .

The external bakcup my disposal is the day 04/27/2015. .

It is interesting that the Tweaking RegistryBackup worked, took the equipment from the blue screen.

So, daily backups with RegistryBackup.

Thank you for your usual attention!


The exchange of anti-virus by another, there was a turnaround. . . The new antivirus has identified some files related to the extensions reported here. . . After the corrections suggested by the antivirus, restart, attempt to open the RegistryBackup Tweaking software and it worked. Download Panda and others who had the same difficulty and everyone went back to work.

Another time I had a hard time Windows updates, the exchange of a virus the other just solving.

HI everyone!

After blue screen, day 05/06/2015. . . Tweaking Registry used with backup 04/19/2015. System returned, but BOTH situations:

1. On the tab of installed programs listed are the programs installed by the date of 04/19/2015, but the installed software after que date until 05.06.2015, Some work Normally software;

2. When I try to start Tweaking RegistryBackup and Windows Repair (all in one), one gets the Following message: "C :. \ Windows \ System32 \ MSVBVM60.dll was not meant to be executao on Windows or contains an error Try install the program again using the original installation medium or contact your system administrator or the software vendor for support '

Same error after fresh installation of Tweaking RegistryBackup.

In the case of Panda Cloud Cleaner: C: \ Program Files (x86) \ Panda Security \ Panda Cloud Cleaner \ psclsp.dll was not designed to run on Windows or it contains.

Used SFC / scannow - found, he corrected some, but not all

Dism / online / cleanup-image / restorehealth

Error: 87.

Strangely, other software, installed after que date function normally. .

I have updated backup, this topic is more to put to discussion. . .

Sorry for my english!


General Computer Support / Re: System Protection - error 0x80070005
« on: September 27, 2014, 04:52:20 AM »
Makes sense

Interesting that there is software like yours, that make life easier for many users of Windows OS.

General Computer Support / Re: System Protection - error 0x80070005
« on: September 26, 2014, 06:26:55 PM »
Did not quite understand what happened, because I was creating restore points without any error, it can be assumed that the VSS was working.

Today, I tested again, and everything is working fine.

As I like to read and participate in various forums in the area of ​​Windows OS, I see lots of complaints from users, many unanswered questions and so many answers that do not resolve the inconsistency. . . One gets the impression that Microsoft is not too worried about them.

General Computer Support / Re: I can not save notepad file (txt)
« on: September 26, 2014, 06:13:57 PM »

A thousand apologies to you and to this forum ... I do not know how happened ..

Found out I was leaving, when you save the file, the extension (txt), along with the file name.

General Computer Support / I can not save notepad file (txt)
« on: September 26, 2014, 11:56:42 AM »
good afternoon

The notepad opens normally, but when I save by choosing Save or Save As, the file generated is not saved, staying open. There is no error message.

Grateful for the attention!

General Computer Support / Re: System Protection - error 0x80070005
« on: September 25, 2014, 02:43:21 PM »
I managed to resolve the difficulty by using the same procedure for cases where it was not possible to create a restore point: Catastrophic Failure 0x8000FFFF Error When Trying to Use MS Backup. The equipment in question I could create the restore point, unlike the solution presented.

The difficulty concerned the protection configuration of the system, not creating restore points.


1 Start:

2 type "services";

3 Scroll down the list of services and double-click the Volume Shadow Copy service.

4 Select Manual from the Startup Type field if it is not already selected.

5 Click the Start button under Service Status

6 Click OK and close the services window.

7 Try to reconfigure the system protection.

See attachment:

NOTE: Remember that if the service is manual, you can change to another starting and then returning again to manual.

In this case, the object of this post, even adopting the procedure, another error appeared, but I was clicking OK, OK, and everything was working. Even rebooting and everything working.

Well, well, well, these are things of the Windows OS.

Remembering that I have OS images, but this gives me the assurance to try other solutions.

General Computer Support / Re: System Protection - error 0x80070005
« on: September 24, 2014, 02:29:06 PM »
Equipment running well. Super fast ..

Already tested .. chkdsk.

I tried all the available backups Registry Tweaking the oldest of 29.08 and nothing changed in the protection system.

In the last restart msconfig returned to work.

General Computer Support / Re: System Protection - error 0x80070005
« on: September 24, 2014, 01:21:35 PM »
There are no restore points, only one, created as a test, when equipment has had difficulty.

Nor is it incompatible antivirus, uninstalled it and nothing has changed.

General Computer Support / Re: System Protection - error 0x80070005
« on: September 24, 2014, 12:14:14 PM »
Complementing information.

Roguekiller found Pum. policies (attached)

The equipment gives the normal boot, but looking msconfig, "System Startup" tab, I have no access to system startup does not have access to any of the options. (attached)

In the "General" tab, access the options is normal, but in an attempt to "apply" has the following information:. "System configuration can not save the original boot configuration for later restoration Changes in The startup will be reversed. device is not ready "

General Computer Support / System Protection - error 0x80070005
« on: September 24, 2014, 07:52:36 AM »
Good morning everyone!

Remembering that my language is not English. . . which may hinder a little communication.

Dell Inspiron N4050, Windows 7-64, Home basic.

Initially "C" (system), increased from one moment to another, the volume.

Observed that it was one of the restore points, which used no less than 30 GB, only he, and all together, used 90 GB. After that point and excluded from some other "C" has returned to normal.

Observed protection system that it found itself changed, using configuration, approximately 98 GB, because usually, I leave an 8 GB for restore points.

The system creates the restore point, changes the amount of GB available, but when I try to use the "apply", have the following information:

"Could not create the scheduled task for the following reason: Access is denied 0x80070005" and unexpected error in the property page

Deactivating and reactivating system protection, same error. Make changes, but it has this error.

Used Combofix, Malwaribytes and other good scanners but nothing relevant was found. . . imaginos then it is not difficult for malware.

Was also used SFC, CHKDSK C: f / r /.

Please positioning.

General Computer Support / Re: Error not specified in ISO files
« on: September 02, 2014, 07:48:46 PM »
I used 7-Zip to extract the files from the ISOs files and no errors occurred.

I begin to wonder who is disagreement with the software multiboots

General Computer Support / Re: Error not specified in ISO files
« on: September 02, 2014, 06:15:46 PM »

As I am not expert in the English language, at some point we can not understand us. . .

I have pen drives, built with multiboot software (Sardu, YUMI, etc), whose interior are several ISOs files and functioning normally. But some ISOs files was not possible its introduction in pen drive. . . have the above reported errors.

Not yet tested ISOs individualment these files, or only one for each pen drive.

Grateful for the attention!


Pages: [1] 2