Main Forum > General Computer Support

System Restore etc

<< < (3/5) > >>

marineraussies:
Hello,
I did the UTube, wrote down the instructions and this is what happened:

HI, I followed the instructions to the letter, however, when I got to the prompt:
takeown/fWindowsApps/r/dY...
I got a message: takedown part it says is not recognized etc
So, I tried it various ways, and still no go. I even skipped that command and went to the next one...nope.
I don't know what to do...thoughts?

Boggin:
Your error may have been not entering the cmd properly if how you have posted it is how you entered it.

There is a space before each / and a space after /f and /d so it should be entered as -

takeown /f WindowsApps /r /d Y

I've just entered that cmd on another Win 10 laptop and the response is exactly as it is in the video.

Create a restore point first before trying it again after checking to see if System protection is enabled.

When you see a particular command, look carefully to see if there are any spaces and copy it exactly like you see it on the screen.

My apologies about where to see the buttons in System protection - you need to click on Configure - a lapse in memory.

It looks like I may have to update my Realtek HD Audio :)

marineraussies:
Thank you for being so patient....I will give it another try after carefully checking for spaces.....

marineraussies:
Hooray!
The system restore RESTORED !!
Thank you for you patience.
Still no volume, but now I will try the real tek install link again and see what happens.

Boggin:
How far back did you restore to ?

You may want to try those cmds on your Dell PC if that gives the same error code when trying the restore points in Safe Mode.

Have you checked the volume level on the taskbar ?

Navigation

[0] Message Index

[#] Next page

[*] Previous page